Parameter calibration of contact contour scan system based on LM algorithm

Home > Archive>Volume 44, Issue 1, 2021 >65-69

Parameter calibration of contact contour scan system based on LM algorithm
DOI:
                        
                    
CSTR:
                        
                    
Author:
                        Gao Tong1Gao Tong
State Key Laboratory of Electronic Test Technology, Key Lab of Instrument Science and Dynamic Measurement, North University of China, Taiyuan 030051, China
Find this author on All Journals
Find this author on BaiDu
Search for this author on this site
Chen Hong1Chen Hong
State Key Laboratory of Electronic Test Technology, Key Lab of Instrument Science and Dynamic Measurement, North University of China, Taiyuan 030051, China
Find this author on All Journals
Find this author on BaiDu
Search for this author on this site
Wang Jinqi2Wang Jinqi
Shanghai Radio Equipment Research Institute, Shanghai 201109, China
Find this author on All Journals
Find this author on BaiDu
Search for this author on this site
Li Jianxin1Li Jianxin
State Key Laboratory of Electronic Test Technology, Key Lab of Instrument Science and Dynamic Measurement, North University of China, Taiyuan 030051, China
Find this author on All Journals
Find this author on BaiDu
Search for this author on this site
Chai Shihao1Chai Shihao
State Key Laboratory of Electronic Test Technology, Key Lab of Instrument Science and Dynamic Measurement, North University of China, Taiyuan 030051, China
Find this author on All Journals
Find this author on BaiDu
Search for this author on this site

                    
Affiliation:1. State Key Laboratory of Electronic Test Technology, Key Lab of Instrument Science and Dynamic Measurement, North University of China, Taiyuan 030051, China; 2. Shanghai Radio Equipment Research Institute, Shanghai 201109, China
Clc Number:TN919.5
Fund Project:

Article

Figures

Metrics

Reference

Cited by

Materials

Comments

Abstract:

In order to solve the contact profile scanner due to defective components are installed and the problem that the deviation caused by the result of the measurement data, this paper analyzes the main source of error, based on the idea of least square method, the minimum residual sum of squares as the optimization target processing error of the system model is established, and establish a set of based on LM algorithm iteration the field calibration method of system parameter, and using Matlab software programming algorithm is verified the feasibility and robustness of algorithm in experiments, simulation experiments data shows that the algorithm can realize accurate calibration of system parameters and coordinates of correction, fast convergence rate, High accuracy can control the measurement error below 0.05mm, Angle error control below 0.1°, greatly reducing the scanner's manufacturing and installation accuracy requirements.

Key words:Parameter calibration; Nonlinear least square method; Iteration; LM algorithm; robustness

Get Citation

Copy

Article Metrics

Abstract:
PDF:
HTML:
Cited by:

History

Received:
Revised:
Adopted:
Online: December 31,2024
Published:

Home

Introduction

Editorial Committee

Policy

Contact Us

中文版

Get Citation

Share

Article Metrics

History

Article QR Code